1986 to 1995 Toyota Early IFS Truss

These trusses/braces are cut out of a single piece of stick of 3.5x3.5x.188 (3/16") wall square tube.  The arch is a 1/2 section of 5" Schedule 40 (1/4" thick) pipe.  All of these materials are extremely strong, in fact much stronger than the frame of your vehicle.

1986 to 1995 Early IFS Truss/Brace.

1986 to 1995 Early IFS Truss/Brace between the two rear a-arm horns.

I will need the measurement between the rear horns on your vehicle.  90% of the trucks out there are 17".  Some may be 16 7/8" or 16 3/4".

Truss/Brace installed.  Drilling is required, you will need to start with the 4 pre-drilled 3/8" holes and finish drilling them through the horns on your truck and then through the back side of the brace.

Five braces ready to be sent out to customers.

Front view of installed brace.

Rear view of installed brace.

Truss with custom aluminum skid plate.

Truss with BudBuilt Cross Member/Skid Plate.

Truss with BudBuilt Cross Member/Skid Plate.

*** This is a SEASONAL product.  We build them in batches when there is enough interest to make a production run. ***

IFS Truss 1986-1995 Toyota Pickups & 4Runners: $100.00 (Unpainted & you provide mounting hardware)

  Be sure to have your measurements when ordering.

You will need to provide 4 (Four) 3/8" or 1/4" Bolts that are 4" long with nuts and washers.

Back to www.sonoransteel.com

e-mail me: steve@sonoransteel.com